说明

• LUJINXUN 1” Tri Clamp 50 Brewing Equipment Heating Tube 1/2/5 TEN 304SUS Quick Connect Chuck Heater Element 1PC Specifications: Product Name: Flange Disc Heating TubeTube Length: 200mm/215mm/260mm/320mm/360mmVoltage: 110V/220V/380VPower: 1/2/3/4/5 Diameter: 8mmThread Diameter: 32mmFlange Disc: 50 (1 Tri-clamp)Tube Material: 304 stainless steelThread Material: 304 stainless steelPackage Contents: According to what you select Pay attention: Power Allowance -10%~+5% 01/Introduction to Heating Tube:This heating tube is used as a heating detail within water tanks, boilers, and water towers for brewing and fermentation equipment. No area what mannequin you choose, you might replace it with the suitable specifications. 02/How to measure the dimensions of heating tubes :① Voltage: 220V or 380V, Power: How many KW② Flange specifications: 51 flange=outer diameter 51mm, sixty four flange=outer diameter 64mm, seventy seven flange=outer diameter 77, ninety one flange=outer diameter 91mm③ Tube length: The length can vary slightly, as long because it can be installed into the method 03/Instructions: 1. Before installation, use a multimeter to test if the heating tube is powered on. If the size is correct, then continue with installation. If the measurement isn't powered on, please contact customer service. 2. The heating discipline of the heating tube should be permanently submerged underwater earlier than the flexibility can be became on, and dehydration and dry burning are strictly prohibited. (Dehydration and dry burning discuss with heating facets which are partly or completely uncovered to the water floor and electrified within the air. As heat cannot be transferred out through water, it is permanently absorbed through method of the steel tube, which might trigger the steel tube physique to reveal black and bulge, or maybe burn, break, or melt.) 3. If the heating kit is supplied with an automated water filling device, the ball valve needs to be recalibrated after every single replacement of the heating tube to make sure that the liquid point is way above the placement of the heating tube before it may be used. To pricey all,1. Heaters are commercial products, not vase. some may have flaws, similar to weld, such as stainless steel trace and varnish trace,that&;s normal. Because the heating twine contained in the heater tube is fabricated from OCr25A15 which is Magnetic, it's common that the element could be adsorbed by means of means of magnet. Under the placement of insulation, the abroad usual for the heater strength accept allowance -10% to 5% you are care about these, please think carefully before make order. We don't accept dispute or damaging suggestions about those you in your attention. Application: The electric heating tube can not totally be used as a heater for closed oil tanks, oil drums and hydraulic oil devices, but in addition as water tanks, boiler heaters, tank heaters, mold temperature machine heaters, etc., and are widely utilized in the heating of tanks-tanks-equipment in electronics, plastics, chemical industry and environmental engineering NOTICEAll applications from our shop are registered site: 17track/en, PAYMENTVISA,Mastercard,WESTERN UNION,Maestro,Bank Transfer,QIVI WALLET,WebMoney,Boletol,PayPal WARRANTY SERVICEDelivery Time:Ship out within 3-5working daysAll emails can be replied within 24 hours REFUND or RESENDIf goods no longer acquired or damaged,please cooperate with us to take photographs when you achieve it, then gift us the evidence,we will refund or resend a new one to you,thanks FEEDBACKAny questions please be at liberty contact with us before you leaving a feedback,we will attempt the best to help you remedy it Immediately.

• 
• 
• 
• 
• 

审核