Açıklamalar

• Piezo Ceramic Ultrasonic Emitter Vibration Wave Cleaner Transducer Dishwasher Bath Oscillator 33khz 60wThe mechanism of ultrasonic cleaning is to make use of the bodily results comparable to cavitation, radiation stress and sound stream in the cleaning liquid. It can exfoliate the package produced by the dust at the cleansing parts, and might additionally promote the chemical reaction between the cleaning liquid and the dirt, in an effort to realize the purpose of cleansing the object. The frequency of the ultrasonic cleaning machine could be chosen by way of 10~500 kHz in keeping with the dimensions and objective of the cleansing material, generally more than 20~50 kHz. With the increase of the frequency of ultrasonic transducer, Langerhans oscillator, longitudinal oscillator and thickness oscillator can be used. In the miniaturization aspect, radial vibration and flexural vibration also are adopted. Ultrasonic cleaning has turn into extra and extra broadly used in assorted industries, agriculture, household equipment, electronics, automobile, rubber, printing, aircraft, food, health facility and clinical research. Ultrasonic vibrator set up process:1. Preparation tools: argon arc welding, hex wrench No. 10, ferrochrome wire, 2 sq. high temperature wire, 2*2 cable wire, vibrator glue, (stripping pliers, casing, cable ties, sand blasting machine, Pipe fittings, etc.), the welding screw: Calculate the location of the vibrator, weld the screw within the wiped clean position, and then clean the screw around, ensure you make it flat, so as not to impact the establish of the vibrator, the glue configuration: squeeze A glue around the screw, then squeeze the B glue around the A glue, then soon stir the AB glue with a small iron rod, so that it is completely combined evenly. Install the vibrating head: Slightly push the transducer to squeeze out the air and additional glue between the lowest and the bottom contact surface, simply so the vibrator is more tightly integrated with the chrome steel as a whole. Curing and solidification: It is cured at a relatively high room temperature, and might be connected in 4-8 hours. After 24 hours, it may be powered on: 1. Metal nailing machine also can update argon arc welding. 2, the welding screws must be completely welded, in any other case it's going to fall off easily, at the curing, the dimensions of time should examine the temperature, the temperature is low for a protracted time, the temperature is high, it's faster, it is strongly recommended to operate at room temperature, even if heated, do not overheat, right Transducer Applications: Used In Ultrasonic Immersible Transducer ultrasonic Cleaning mechanical device Ultrasonic Cleaner and Ultrasonic Pipe Cleaning,Ultrasonic Mixer etc.

• 
• 
• 

Gözden geçirmek