Açıklamalar

• p{margin-block-start: 0; margin-block-end: 0} Feature: Name:CNMI 100:27 AB Carbon Fiber Special Dipping Glue Modified Epoxy Resin Easy Penetration Resin DIY Model Airplane Crafts Supplies Notice:The epoxy resin glue could turn yellow after receiving the package, which doesn't impression the performance of the product and can be used normally. Package:A1000g-B270g/A35.2oz-B9.5oz; Product Features: This product is straightforward to operate, and the foam is easily disappeared after stirring. After curing, high gloss, no bubbles, and pits. varied carbon fiber cloth manual DIY, marble, wood, metallic solar panels, Surface policy protection. Application method: Strictly in step with the load ratio of A: B = 100:27 by way of weight for reconciling, the percentage can be adjusted in step with the actual situation. Stir slowly and thoroughly, then it must stand for 2-5 mins earlier than using, in order to management the era of bubbles. Please run out of sth it within 25-30 mins below typical temperature (25℃). Attention Please ①. Due to the extreme temperature in summer, the ready time can be shortened after mixing. It can be used after status for roughly 2 minutes. ②. The temperature is low in winter, the viscosity of the resin will increase. A glue would be preheated correctly to reduce the viscosity and then proportioning. Cautions: It isn't always suitable to mix too much glue at a time, using it straight when blending well. The greater the temperature is, the shorter the applying period is;On the contrary, the longer. After the resin perfusion is done, if the resin layer is found to have bubbles, use a high-quality needle to break the bubble, the bubble will automatically rise. During the operation, please preserve our environment clean and prevent dust pollutants products. combined glue throughout curing, the curing agent will absorb the moisture, when the air humidity is large, the skin of the cured floor can have a layer of oil. Therefore, it's stored dry through the curing, and don't treatment in a enormous environment of humidity. When there may be an oily, the outside can be dried, after which the sandpaper is polished. when the temperature is lower than 15 degrees, the resin can have a crystalline phenomenon, which will change into a haze, flocculation, and solidification right into a white solid. When used, the resin can be warmed, the temperature is high, and resin When the outlet is transparent, it's used again and does not affect the curing performance. Use alcohol to clean the excess glue on the hand or the stickies before curing. In case of contact with skin, rinse with clear water. If it is serious, see a doctor. Cover tightly after using, don't blend covers. Keep out of the reach of children, don't enter the mouth! Before utilizing this product, please try it prematurely to bypass mistakes!

• 
• 
• 
• 
• 

Gözden geçirmek