Описание

• NTT AT6001 UV glue optical waveguide adhesiveOptical adhesive for optical waveguidesNTT-AT6001 glue NTT AT3727E is used for bonding FAThe attribute of UV glue is its provider life, the retention era before opening the hexa is 6 months, and the lid is three months after opening.Characteristics 1. Accurate refractive index control2. Wet bonding reliability design3. Uv stabilizationCuring conditionsUV mild source: 300-400nm output (metal lamp, mercury lamp, etc.)Irradiation intensity: 10mw/cm2(at 365nm wavelength)Irradiation time: greater than 10 minutes (explanation: would be in line with precise needs, take step curing method, such as:step1: 10mw/cm2, ninety seconds;Step 2:20mW/cm2, ninety seconds;Step 3:40mw, ninety seconds.After three steps, the complete calories absorbed by way of the glue is 6300mJ, which exceeds the 6,000MJ curing energy required via the glue. However, we do not put forward utilizing too excessive an influence for brief periods of time. Customers can in step with the situation, first test, and then batch) the above conditions will replace in line with the thickness of the UV mild source and the glue layerIf the UV curing could be heated according to the ensuing conditions, the functionality of the glue will be steady heating conditions: 50~60℃, heating 0.5~1 hour (explanation: The purpose of heating treatment is to release stress. After heating, it needs to be 2℃/ minute, pure cooling, in a roundabout way take the machine out of the oven after the end.) Note: This glue is anaerobic, so the part exposed to air usually are not cured. (Explanation: that is, a layer of glue on the floor won't cure, yet as long as the glue absorbs more than 10mW/cm2 × 10min × 60sec= irradiation quantity of 6000mJ energy, the inside of the glue layer and the a part of the system will be permanently cured)Storage Glue must avoid direct mild and excessive temperature. Please live far from fireplace and different heat sources. We put forward storing in a drying oven. Be sure to word that glue will degrade when it absorbs moisture. (Explanation: All Uv glue is terrified of moisture. It is suggested to shop it in a drying oven. The ambient humidity is recommended to be less than 35%RH.)

• 
• 

Отзывы