Opisy

• Marvell 88SE9215 chip 6 ports SATA 3 to PCIe expansion Card PCI specific SATA Adapter SATA 3 Converter with Heat Sink for HDD About Description: Features: Compliant with Serial ATA 3 specification, backward well suited with SATA2 SATA1 Compliant with PCI-Express v2 specification, backward well suited with PCI-Express v1 Supports communique speeds of 6 Gbps, 3 Gbps and 1 Gbps Support Gen 1i, Gen 1x, Gen 2i, Gen 2m, Gen 2x, and Gen 3i Support 6 SATA Support AHCI1 mode and IDE mode Support for native command queue (NCQ) Support FIS in accordance with port multiplier switch or command switching Support hot switch and hot swap Compatible with SATA6G, 3G and 1 difficult drives Bus interface: PCI-Express x1 slot Expansion interface: 6 SATA3 interfaces System Requirements: One PCI Express X1 slot is available, supporting both PCI-E X2 X4 X8 X16 Operating system: Windows10/8/7 (32/64 bit) / Vista (32/64 bit) / XP/2003/2008/linux Product driver file: 1 CD: DRIVER\SATA CARD\Marvell\91XX_92XX Setup, then select the suitable folder consistent with the formula The PCIE to SATA3 riser card is used as follows: First, the formula disk and PCIE to SATA3 riser card connection situations and solutions: 1 The SATA interface mode of PCIE to SATA3 is AHCI mode If you desire to plug within the components disk on our card, the idea is that your system disk ought to be put in in AHCI mode when putting in the components on the motherboard Otherwise, it'll now not pass Our card riser card starts the components 2 If it is desperate that the SATA interface installation system of the formulation disk inserted in the motherboard is AHCI mode, then you can immediately insert the hard drive into our card, after which input the motherboard BIOS to set the system disk because the first boot 3, the above two conditions are available, if it nonetheless can't start, or repeated reboots, then the motherboard's hard disk drive interface and our adapter card conflict, the answer is to go into the motherboard BIOS, set the motherboard's hard disk interface solutions to Disabled, save and restart to begin the formulation Second, the average disk and PCIE to SATA3 connection circumstances and solutions: 1 When the formulation disk is plugged into the motherboard, the ordinary disk is inserted within the PCIE to SATA3 card, then solely the adapter card news and the normal disk mannequin should be detected at startup 2, if the situation is established, or can't start the system, then you should input the motherboard BIOS, set the formulation disk to the 1st boot Third, the system disk and the standard disk and PCIE to SATA3 connection and solution: 1 Prerequisites, if the system disk with the original motherboard put in components is AHCI mode test, can use the ensuing methods to achieve, if it's IDE mode put in system, you then can only reinstall the formula via PCIE to SATA3 2, 1 condition is established, you cannot start to input the motherboard BIOS, set the components disk to the 1st boot 3, 1 circumstances are met, or can't start, then it can be incorporated SATA interface conflict, please enter the motherboard BIOS to set SATA to Disabled You'll receive: 1 x SATA III (6Gbps) 6-port PCI-Express Controller Card Please check photos for extra details

• 
• 
• 
• 
• 

Recenzja