Preces apraksts

• This is two E-Ink show HAT for Raspberry Pi,250x122 resolution, with embedded controller, communicating by way of SPI interface, supports partial refresh. Due to the advantages like ultra low strength consumption, large viewing angle, clean demonstrate with out electricity, it is a preferrred choice for functions reminiscent of shelf label, commercial instrument, and so on. No backlight, retains displaying final content material for decades even though strength down Ultra low strength consumption, essentially strength is barely required for refreshing Standard Raspberry Pi 40PIN GPIO extension header, supports Raspberry Pi series boards, Jetson Nano. Preserved solder pads for SPI interface, for connecting with assorted controller boards like Arduino/Nucleo, and so forth voltage translator, well matched with 3/5V MCUs Operating voltage: 3/5V. Interface: SPI. Outline dimension: 65mm x 30. Display size: 23 x 48. Dot pitch: zero x 0. Resolution: 250 x 122. Display color: black, white. Grey level: 2. Partial refresh time: 0. Full refresh time: 2s. Refresh power: 26(typ.). Standby power: 170°. color:Blue Material:PCB Package Contents: 1 x 2 e-Paper HAT 1 x RPi screws pack 1 x 20cm 8Pin Cable Only the above package content, other products are usually not included. Note: Light taking pictures and different displays could cause the colour of the object in the photograph barely diversified from the genuine thing. The measurement allowed error is +/- 1-3cm.

• 
• 
• 
• 
• 

Atsauksmes