Preces apraksts

• 1. With the blue caps in place wash the outside of every fluoride clear out Elements with water and mild dishwashing soap, then rinse. With clean hands, remove both blue caps from every single end of both clear out Elements. 2. Place the rubber priming button (tan colored) onto one finish of a fluoride clear out and align the outlet of the filter with the hole of the rubber washer. Press the priming button up against the sink tap simply so the priming button creates a seal between the faucet and the Fluoride Filter. Place your thumb on height of the tap to apply pressure, to create a better seal (as seen in picture). 3. While retaining the priming button against the faucet, activate the cold water slowly, allowing water to fill the cavity of the filter and movement from the other end. Allow water to motion for no less than 30 seconds or until water runs clear. 4. Turn the Fluoride filter over and high the other end (reversing the circulate of water) repeating steps 3-5 until water runs clear from either directions. 5. To decide if the filter is absolutely primed, assemble the filtered water in a clear glass and keep it as much because the light to look if all of the cloudiness is long gone from the water, if no longer continue priming until water is clear. This clear out is now primed and ready to install. Repeat priming steps 1-7 for every extra Fluoride Filter. [High-efficiency Filtration]: Replacement for PF-2 fluoride filters efficiently lower fluoride and arsenic, absorb odor, color, residual chlorine, heavy metals, additionally they decrease sediments and large debris fine in recovering taste Colour:White Material:plastic Package Contents: 2 x Water Filter 1 x Rubber ring Only the above package content, diverse item aren't included. Note: Light reflection and different displays may cause the color of the thing within the photograph just a little diversified from the real thing. The size allowed error is +/- 1-3cm.

• 
• 
• 
• 
• 

Atsauksmes