Preces apraksts

• Electric paint scraping machine copper wire enameled peeling scraping paint knife motor repair tool charging model 110V/220V Structure and composition: 1. The hand-held electric scraper is composed of an electronic stepless regulator, a single-phase series motor and a scraper. It features lightweight and durable microswitches and rotating carbon brushes. It has the characteristics of fast coating speed, high efficiency, simple operation, simple installation, stable quality, low failure rate, high production efficiency and novel design. 2. The stationary electric scraper is composed of power components (single-phase and series excitation motors), scraper and governor.一,The operation method: 1. Insert the enameled wire end to be painted into the center of the tool holder, press the power start switch (handheld) or the pedal governor (fixed), and the motor will rotate. 2. Move the enameled wire in the opposite direction to the axial direction until the end of the enameled wire, then the film can be scraped off. 3. Release the power button switch (handheld) or loosen the governor (fixed). 4. To replace the work, repeat the above steps. 二,Wire diameter adjustment and related matters: 1. When the specifications of the enameled wires are different, the adjustable speed potentiometer (handheld) or the adjustable speed governor (fixed) can be adjusted. The wire diameter in the slow direction is small, and the wire diameter in the fast direction is adjusted. If the film does not peel, increase the spin speed until it is scraped off. If the enameled wire is cut by the scraper during speed regulation, the speed should be reduced until it meets the requirements. According to the above method, selecting the most suitable rotational speed as the working speed of the corresponding wire diameter can be considered as adjusted. 2. When scraping the paint to the end of the enameled wire, do not disengage the three blades immediately. The intersection of the cutting edge should wait for the tool to stop rotating before disengaging, so as to avoid the enameled wire suddenly breaking the cutting edge and damaging the cutting edge when rotating. 3. The shell is made of pressure-resistant plastic material, which is safe and reliable. 4. Before the enameled wire is scratched, the hand must be straightened manually to prevent the enameled wire from reaching the center of the blade. 5. After long-term use, in the case of no power supply, the safety cover can be unscrewed to remove the peeling paint film powder.Model: DF-8 Speed: 1000r/min Wire diameter: 0.3-3.0mm Power: 25w Length: 2-50mm

• 
• 
• 
• 
• 

Atsauksmes