Preces apraksts

• 1. With the blue caps in place wash the exterior of every fluoride filter Elements with water and mild dishwashing soap, then rinse. With clean hands, get rid of both blue caps from every single end of either filter out Elements. 2. Place the rubber priming button (tan colored) onto one end of a fluoride filter and align the outlet of the filter out with the opening of the rubber washer. Press the priming button up against the sink faucet just so the priming button creates a seal between the tap and the Fluoride Filter. Place your thumb on height of the tap to apply pressure, to create a extra in-depth seal (as considered in picture). 3. While conserving the priming button opposed to the faucet, turn on the bloodless water slowly, permitting water to fill the hollow space of the filter out and circulation from the opposite end. Allow water to stream for no lower than 30 seconds or until water runs clear. 4. Turn the Fluoride clear out over and high the other end (reversing the flow of water) repeating steps 3-5 till water runs clean from both directions. 5. To choose if the clear out is solely primed, collect the filtered water in a clear glass and keep it as much as the light to look if all of the cloudiness is long past from the water, if no longer continue priming till water is clear. This filter is now primed and able to install. Repeat priming steps 1-7 for every further Fluoride Filter. Material: plastic colour: White Package Contents: 2 x Water Filter(Due to different product batches, the appearance of the elements on the product may be different, but this would not affect use) Only the above package content, different merchandise shouldn't included. Note: Light reflection and assorted reveals can cause the colour of the article in the photograph somewhat assorted from the real thing. The measurement allowed error is +/- 1-3cm.

• 
• 
• 
• 
• 

Atsauksmes