Description

• How to use our wallpaper? STEP 1: Prepare the wall floor Your wall must be permanently flat, clear and dry Levels tough surfaces, rough, holes and uneven spots Your wall must be a uniform colour If not, you would possibly note variations in shade in your wall as soon as installed If your wall has a number of colors, we promote that you just paint back Make a vertical line with a plumb line at the left fringe of the area you would like conceal with the mural If you've a plumb, one can make your own by means of tying a heavy object at the end of a rope This line is significant since it is the instruction manual to begin placing your mural STEP 2: Prepare the wallpaper The wallpaper panels are made with a width of forty eight cm(19") Panels are obtained published always on a roll and numbered at the height Cut independent panels and do a preview at the ground following the numerical order from left to right Measure with a meter the height of your wall If it&;s less than the photomural, you need to minimize it to slot correctly Do it if you have it at the surface but go away a margin of an inch to appropriate any differences in level on the wall STEP 3: Prepare the glue You may perhaps buy the glue from your supermarket, confirm it&;s for non-woven wallpaper use Prepare the glue following the directions at the bag of the glue you purchased Do it slowly So you may achieve a uniform mixture and without bubbles STEP 4: Attach the paper to the wall Applying glue on the wall frivolously utilizing a broom or a paint curler Start distributing from the road you marked as a instruction manual to the plummet Don&;t paste the whole wall, do it only in the field which will conceal the first panel at the left, leaving about a inches exterior the proper Apply the first panel of the mural at the wall beginning on the height left Check that's aligned with the instruction manual Presses opposed to the paper with a dry curler or sponge to take away any air bubbles Place the ensuing panels in the identical method in numerical order The panels must never be mounted on each other yet are set on edge Clean the excess glue with a damp sponge STEP 5: Finishing With the aid of a ruler and a cutter, alter the edges and the end and bottom of the wall if needed Let dry 24 hours; you'll get a perfect outcome

• 
• 
• 
• 
• 

Review