Description

• Coffee Grinder Parts 64mm Cutter Plate For Heycafe HC600 HC-600 Faema 900N Mazzer SUPER JOLLY LEHEHE Bean GrinderPrecautions for cutter head establish ！！！！！① : After cutting off the outdated cutter head, we have to freshen up all of the inside residue, the cleaner the better!② : The three fixing screws of the cutter head must be tightened evenly③ After the set up of the recent cutter head, it needs to be manually grew to change into to test④ Test method: unscrew the massive screw within the center of the cutter head through way of hand. If the fighting a part of the better and reduce cutter head has 50% area, you could tighten it and then regulate the thickness of the powder, use! If there could also be much less battling a part of the cutter head, you should regulate the trail of the cutter head and then test, till the fighting discipline is as above, you may upload powder debugging, use! The higher cutter head has three corners and may be adjusted in 3 directions! The combating section is less, and the grinding powder cannot be adjusted since the thickness can be quite thick, and it's going to not be adjusted. Note: Due to the iron content material of the material, the skin might be oxidized. Not second-hand or defective products, don't influence the use, as long as the mechanical device grinds some espresso beans, oxidized part will disappear diameter: 37mmOuter diameter: 64mmThickness: 8 modelSuitable for 64mm flat knife grinder modelsApplicable models: Pegasus 900N grinding machine, HEYCAFE HC600, MAZZER mini grinding machine, Jetstar JX600, Lehe, MAZZER Super jolly and varied units are 64mm flat knife grinding disk could be applicableTips :MAZZER sequence Major V, Kony S, Robur S, ZM and various grinders cannot be used

• 
• 
• 
• 
• 

Review