Description

• This public sale is for 50pcs sq. 25mmx25mm 3M 1600T Double Sided TapeBrand: 3MModel: 1600TSize: 25mmx25mmPE FOAM TAPEColor: WhiteThickness: Around 1mmRecommended Applicationshooks,decorations,door plate bonding,and etc.Strong sticky tape. Easy to use.Tips for application: the application floor needs to be free of oil stain,dust,moisture. Dry and clear surfaces shall have larger bonding effets.How to apply this tape?Clean:For maximum bond strength,the surface should be clean, dry, smooth, don't have any rust and oil pollution.Typical cleaning solvents are heptane or isopropyl alcohol.Pressure: Pressure at the adhesive and the skin might help upgrade bond strength,roller or platen would be used.Time: After application, the bond energy increases as the adhesive flows onto the surface. At room temperature approximately 50% of ultimate bond power might be done after 20 minutes, 90% after 24 hoursand 100% after 72 hours.Temperature:Ideal software temperature differ is 70°F to 100°F (21degree centigrade to 38degree centigrade).Operating temperature shouldn't be below 10 degree centigrade, the temperature is simply too low, will end in cure time longer. If temperature is simply too low, movement materials and adhesive tape into the warm indoor garage or heating treatment.Q. What percent of the ultimate bond strength can I anticipate instantly after application? After 24 hours? After seventy two hours?A. Immediately after an utility is made, about 60% of the bond strength is achieved. As the adhesive continues to wet-out the surface, you might count on the bond to be at about 75% - 80% after 24 hours. After72 hours, 95%+ of the bond strength is achieved. The bond will proceed to build with time.Q. Is the tape solvent resistant?A. Yes, 3M acrylic foam tapes are resistant to commonest automotive solvents like gasoline, diesel fuel, washer solvent, etc. Solvent resistance is a operate of sort of solvent, time of exposure and temperature.Q. Why doesn`t the tape really feel sticky?A. 3M`s excessive performance acrylic adhesives tend to be agency and dry to the touch. They are designed to bond supplies apart from skin.The adhesives used are designed to offer optimal performance and adhesion to car substrates and components. The pure oils and moisture of pores and skin canvary from user to user and affect the "thumb appeal" of the 3M Acrylic Foam Tape. To one consumer the tape can really feel very sticky and to a different it would really feel much less sticky to the touch. The difference in "thumbappeal" is within the variation of the two individual`s pores and skin surfaces not the adhesive.Q. The part is not adhering to the vehicle. What is probably wrong?A. Areas to enquire for poor adhesion or performance include:Check for floor contamination. The substrates needs to be clear and freed from any contaminant. This is the commonest reason for deficient adhesion.Check for surface match. Are the two surfaces to be bonded a reputable match?Check for proper utility pressure and wet-out.Check the again of the component for flatness.Check the installation job for correct procedures.

• 

Review