Description

• 1. With the blue caps in place wash the outside of each fluoride filter Elements with water and mild dishwashing soap, then rinse. With clean hands, get rid of both blue caps from each end of either filter out Elements. 2. Place the rubber priming button (tan colored) onto one finish of a fluoride filter out and align the hole of the filter out with the outlet of the rubber washer. Press the priming button up against the sink faucet just so the priming button creates a seal between the tap and the Fluoride Filter. Place your thumb on height of the tap to apply pressure, to create a extra in-depth seal (as viewed in picture). 3. While preserving the priming button against the faucet, switch on the bloodless water slowly, allowing water to fill the cavity of the filter and motion from the alternative end. Allow water to stream for no longer lower than 30 seconds or until water runs clear. 4. Turn the Fluoride filter out over and high the choice end (reversing the stream of water) repeating steps 3-5 until water runs clear from both directions. 5. To decide if the clear out is absolutely primed, assemble the filtered water in a transparent glass and keep it as a lot as the sunshine to see if all of the cloudiness is long gone from the water, if not continue priming till water is clear. This filter out is now primed and able to install. Repeat priming steps 1-7 for each further Fluoride Filter. Material: plastic colour: White Package Contents: 2 x Water Filter(Due to varied product batches, the appearance of the elements at the product may be different, yet this does not affect use) Only the above package content, other products aren't included. Note: Light reflection and sundry reveals can cause the color of the thing in the picture a bit varied from the genuine thing. The length allowed error is +/- 1-3cm.

• 
• 
• 
• 
• 

Review