विवरण

• Feature: Name:CNMI 100:27 AB Carbon Fiber Special Dipping Glue Modified Epoxy Resin Easy Penetration Resin DIY Model Airplane Crafts Supplies\ Package:A100g-B27g/A3.52oz-B0.95oz;A300g-B81g/A10.58oz-2.85oz; A500g-B135g/A17.63oz-B4.76oz;A750g-B203g/26.45oz-B7.16oz Notice:The epoxy resin glue might flip yellow after receiving the package, which does not impression the performance of the product and may be used normally. Product Features: This product is straightforward to operate, and the foam is well disappeared after stirring. After curing, excessive gloss, no bubbles, and pits. different carbon fiber fabric guide DIY, marble, wood, steel photo voltaic panels, Surface policy protection. Application method: Strictly per the burden ratio of A: B = 100:27 through weight for reconciling, the share is also adjusted in line with the actual situation. Stir slowly and thoroughly, then it must stand for 2-5 minutes before using, with the intention to control the generation of bubbles. Please run out of sth it inside 25-30 minutes beneath common temperature (25℃). Attention Please ①. Due to the high temperature in summer, the waiting time can be shortened after mixing. It can be utilized after standing for approximately 2 minutes. ②. The temperature is low in winter, the viscosity of the resin will increase. A glue could be preheated wisely to lessen the viscosity and then proportioning. Cautions: It isn't always compatible to combine an excessive amount of glue at a time, using it instantly when blending well. The larger the temperature is, the shorter the appliance period is;On the contrary, the longer. After the resin perfusion is done, if the resin layer is located to have bubbles, use a tremendous needle to interrupt the bubble, the bubble will mechanically rise. During the operation, please maintain the environment clean and forestall grime pollution products. combined glue during curing, the curing agent will soak up the moisture, when the air humidity is large, the outside of the cured floor may have a layer of oil. Therefore, it is saved dry throughout the curing, and don't treatment in a massive surroundings of humidity. When there may be an oily, the outside can be dried, and then the sandpaper is polished. when the temperature is lower than 15 degrees, the resin may have a crystalline phenomenon, that may change into a haze, flocculation, and solidification right into a white solid. When used, the resin would be warmed, the temperature is high, and resin When the hole is transparent, it's used again and would not impact the curing performance. Use alcohol to wash the excess glue at the hand or the stickies earlier than curing.  In case of contact with skin, rinse with clear water. If it's serious, see a doctor. Cover tightly after using, don't blend covers. Keep out of the attain of children, do not input the mouth! Before using this product, please attempt it prematurely to avoid mistakes!

• 
• 
• 
• 
• 

समीक्षा