Beschreibung

• Automatic Solar Panel Battery Charger Board Night Light LED Lamp Control Switch Battery Charger Charging Controller Module Features: 1 Using high quality materials, the quality is guaranteed 2 Photovoltaic solar charge and discharge computerized management switch, suitable for a wide range of battery voltages 3 Simple and transportable to use four Charge during the day, robotically switch on the light when it's dark, and automatically flip off the light when it's shiny five The low-power controller is suitable for photo voltaic garden lights, garden lights, colourful string lights, small road lights, and many others Description: Charging within the daytime, routinely turning on the lighting fixtures at night, and robotically turning off the lights at dawn, the output voltage is the output voltage when the battery has no voltage The circuit controls the output through detecting the replace of the voltage generated by way of the solar panel, without the will for photosensitive elements; it is suitable for a wide range of batteries Wiring Method: 1+B- related lithium battery 2 S+ S- connect with photo voltaic panel 3 L+L- output Wiring Sequence: 1: Connect the lithium battery, the battery should have the corresponding protection board 2: Connect to the LED, the lithium battery has energy and the LED lights up 3: Connect to the photo voltaic panel At this time, the photo voltaic panel is illuminated with light, and the LED is off, and the LED is on without light The swap could be installed if it ought to be became off at night or the swap interface SW has been reserved for transportation and garage Precautions: 1: The secure operating output latest of the control board cannot be more than 600ma, in any other case it may trigger output protection 2: Charging and anti-backflow with out overcharge and overdischarge defense Lithium batteries ought to be used with corresponding protection forums (mobile telephone batteries all have 3 protection, and more than 18650 do not have them three defense forums can't be utilized in series) 3: Pay attention to waterproofing and insulation 4: LED lamps cannot use boost pressure 5: The battery voltage of the controller is the output voltage, unlimited current and voltage limiting, 2V3V LED lamp beads cannot be used directly, it needs to be driven by means of a step-down constant recent or a chain current proscribing resistor, and the output recent is the utmost working current, no longer constant current Note: 1: The output strength is the particular power, please verify the particular strength intake of the load before use 2: Direct access to 3Vled may perhaps damage the controller or LED 3: The battery needs to be geared up with a protective plate, and the battery voltage should match the open circuit voltage of the solar panel Package Included: Solar control change circuit board with terminal*1 Terminal wire*3 or Solar control switch circuit board with out terminal*1 or Solar control swap circuit board with out terminal*2

• 
• 
• 
• 
• 

Rückmeldung